Eastman Turbo Oil 2380 in (5) gallon pail
Eastman Turbo Oil 2380 is a 5 cSt synthetic lubricant that is approved against US military specification MIL-PRF-23699F-STD, and UK specification DEF STAN 91-101/2 (replaced DERD 2499). This lubricant provides a balanced combination of thermal and oxidation stability, load carrying capacity, lower volatility and has the best low temperature flow characteristics of all 5 cSt turbine oils. BP Turbo Oil 2380 is recommended for the lubrication of most aircraft gas turbines and accessories. It is also recommended for the lubrication of aero-derived gas turbines in industrial power generation, offshore and marine applications. BPTO 2380 has been approved by a wide range of engine and accessory manufacturers for their applicable equipment, including: Rolls Royce Ltd, Allison, GE, Pratt & Whitney, Pratt & Whitney Canada, Honeywell, Hamilton Sundstrand, CFMI, IAE, MTU, Solar and Turbomeca, etc. Viscosity: BP Turbo Oil 2380 has the best low temperature viscosity characteristics among all 5 cSt oils. Cleanliness: Minimum formation of varnish and sludge deposits over long periods of use. Seal Material Compatibility: Very benign to commonly used seal materials in gas turbines. Load Carrying Capacity: BP Turbo Oil 2380 is among the best of its class and provides excellent protection to bearings, gears, and other highly loaded lubricated surfaces. Bulk Stability: Its high degree of oxidation resistance permits a long period of operation without significant increase in viscosity and/or total acidity.
This oil was formerly called BP2380
Click for Eastman 2380 MSDS
Click for Eastman 2380 TDS
Save on Oil filters! Click here for Champion and Tempest Oil Filters
| Typical Properties |
| Property |
Test
Method |
Typical Value, Units |
| Density @ 15°C |
ASTM D 1298 |
0.9749 kg/L |
| Viscosity, Kinematic |
|
|
ASTM D 445 |
4.97 mm2/s |
|
|
ASTM D 445 |
24.2 mm2/s |
|
|
ASTM D 2532 |
7,950 mm2/s |
| Pour Point |
ASTM D 97 |
-57°C |
| Flash Point |
ASTM D 92 |
265°C |
| Total Acid Number |
SAE ARP5088 |
0.43 mg KOH/g |
| Evaporation Loss 6.5 hrs @ 204°C |
ASTM D 972 |
3.0% |
| Foaming Volume |
|
|
ASTM D 892 |
9/0 ml/vol |
|
|
ASTM D 892 |
8/0 ml/vol |
|
|
ASTM D 892 |
8/0 ml/vol |
| Load Carrying Ability a |
|
|
IP 166 |
99% |
|
|
IP 166 |
86% |
| Rubber Swell |
| |
Nitrile Rubber (192 hrs @ 130°C) |
|
DERD Test, Method 4 |
10.5% |
| |
Viton Rubber (192 hrs @ 200°C) |
|
DERD Test, Method 4 |
22.5% |
| |
Silicone Rubber (192 hrs @ 175°C) |
|
DERD Test, Method 4 |
10.5% |
| |
Viton LCS Rubber (192 hrs @ 200°C) |
|
DERD Test, Method 4 |
14% |
